Nerf Phone Number



 

Description

Nerf is a maker of athletic sports equipment and toy guns.

Nerf Corporate
Hasbro Address:
1027 Newport Avenue Pawtucket, RI 02861 USA

Nerf Hours
Monday - Friday 9 AM - 8 PM EST
Saturday - 10 AM - 6.30 PM EST

More Phone Numbers
Tech Support: 1-800-255-5516
Corporate: 1-401-431-8697
Hasbro Toy Shop: 1-800-408-0052

Phone Number

PhoneHint
1-800-255-5516Review and Hint Needed
 

Comments

 out of   based on 29 reviews.
Sort by:  Newest  Most Viewed  Oldest
Date Rating Comment
12/30/2015 Nerf DART TAG SPEEDLOAD 6 Instructions and how to
Nerf DART TAG SPEEDLOAD 6 Instructions and how to use

A few tips to consider for optimal blaster performance:
1. Check the sliding door on the side is fully closed.
2. Are more than 6 darts loaded in the clip? 6 darts is the maximum capacity.
3. The cocking mechanism needs to be fully pulled back to fire.

What if a dart gets jammed in my blaster?
Point the blaster at the ground to clear darts from the barrel. Pull the slide all the way back to open jam clearing door. Use the tip of a pen to move the slide inside the clip up and down to loosen darts jammed inside. Fully close the jam clearing door after jammed darts are removed, or blaster will not fire.

CsN TeamRead More
12/30/2015 Instructions and how to use Nerf DART TAG QUICK 16
Instructions and how to use Nerf DART TAG QUICK 16

few tips to consider for optimal blaster performance:
1. Check the sliding door on the side is fully closed.
2. Are more than 16 darts loaded in the clip? 16 darts is the maximum capacity.
3. The cocking mechanism needs to be fully pulled back to fire.

What if a dart gets jammed in my blaster?
Point the blaster at the ground to clear darts from the barrel. Make sure the slam fire handle is pulled all the way back to open jam clearing door. Use the tip of a pen to move the slide inside the clip up and down to loosen darts jammed inside. Fully close the jam clearing door after jammed darts are removed, or blaster will not fire.

CsN TeamRead More
12/30/2015 Nerf - VORTEX VIGILON Instructions and how to use
VORTEX VIGILON Instructions and how to use

A few tips to consider for optimal blaster performance:
1. Are more than 5 discs loaded? 5 discs is the maximum capacity.
2. All of the discs should be loaded with the NERF logo facing up in the clip.
3. Pull the blaster cocking mechanism all the way back then pushed forward all the way.
4. Please note blaster will not cock if no disc is loaded.

What if a disc gets jammed in my blaster?
On the side of the blaster, there is an orange slide which releases the discs. Angle the blaster downward and press the orange ‘disc release’ slide until disc falls out of the barrel.

CsN TeamRead More
12/30/2015 Nerf - Instructions for VORTEX PYRAGON and tips on how to
Instructions for VORTEX PYRAGON and tips on how to use the gun

A few tips to consider for optimal blaster performance:
1. Check that the drum has been properly inserted.
2. Make sure all of the discs have been loaded with the NERF logo facing up.
3. Are more than 40 discs loaded? 40 discs is the maximum capacity for this blaster.
4. Pull the blaster cocking mechanism all the way back then pushed forward all the way to fire.

What are some tips for loading the DISC DRUM?
1. One at a time load discs into the 40-disc drum.
2. First load up to 19 discs with NERF logo facing up.
3. Push lever on top to rotate drum and then release.
4. Add 7 more discs and then push lever to rotate the drum.
5. Continue adding darts until you reach 40. The cartridge advance lever will no longer move once the drum is full.

What if a disc gets jammed in my blaster?
On the side of the blaster, there is an orange slide which releases the discs. Angle the blaster downward and press the orange ‘disc release’ slide until disc falls out of the barrel.

CsN TeamRead More
12/30/2015 Nerf VORTEX PROTON Instructions on how to use
Nerf VORTEX PROTON Instructions on how to use the blaster.

A few tips to consider for optimal blaster performance:
1. Only 1 disc can be loaded.
2. The NERF logo on the disc should be facing up.
3. Confirm the loading tray is fully closed.

What if a disc gets jammed in my blaster?
On the back of the blaster, there is a green button which releases the discs. Angle the blaster downward and press the green ‘disc release’ button until disc falls out of the barrel.

CSN TeamRead More
12/30/2015 NERF VORTEX PRAXIS Instructions and tips on how to
NERF VORTEX PRAXIS Instructions and tips on how to use the blaster

A few tips to consider for optimal blaster performance:
1. Are more than 10 discs loaded? 10 discs is the maximum capacity for the VORTEX PRAXIS blaster.
2. All of the discs should be loaded with the NERF logo facing up in the clip.
3. Pull the blaster cocking mechanism all the way back then pushed forward all the way to fire.

What if a disc gets jammed in my blaster?
On the side of the blaster, there is an orange slide which releases the discs. Angle the blaster downward and press the orange ‘disc release’ slide until disc falls out of the barrel.


CSN TeamRead More
12/30/2015 Nerf VORTEX NITRON instructions and tips on how to
Nerf VORTEX NITRON instructions and tips on how to use the blaster

A few tips to consider for optimal blaster performance:
1. Make sure fresh batteries are loaded.
2. Are more than 20 discs loaded? 20 discs is the maximum capacity.
3. All of the discs should be loaded with the NERF logo facing up.
4. Confirm the clip has been properly inserted.
5. When firing: press and hold bottom trigger for 2 seconds, you should hear motors spinning, then press top trigger to fire discs.

What if a disc gets jammed in my blaster?
Find the green tab on top of the blaster. Remove clip first, angle blaster downward, then slide back the green tab until disc falls out. After disc falls out, slide tab all the way forward so there is no orange circle visible on top of the blaster.

CSN TeamRead More
12/30/2015 Nerf VORTEX LUMITRON How to use and instructions
Nerf VORTEX LUMITRON How to use and instructions

A few tips to consider for optimal blaster performance:
1. Are more than 10 discs loaded? 10 discs is the maximum capacity.
2. All of the discs should be loaded with the NERF logo facing up in the clip.
3. Make sure the clip is inserted.
4. Pull the blaster cocking mechanism all the way back then pushed forward all the way.
5. Please note blaster will not cock if no disc is loaded and the blaster does not have a 'slam-fire' feature.

What if a disc gets jammed in my blaster?
On the side of the blaster, there is an orange slide which releases the discs. Angle the blaster downward and press the orange ‘disc release’ slide until disc falls out of the barrel.

CherryRead More
12/30/2015 Instructions and how to use Nerf N-STRIKE STAMPEDE
Instructions and how to use Nerf N-STRIKE STAMPEDE

A few tips to consider for optimal blaster performance:
1. Is the sliding door on top fully closed? A green circle will be visible when the door is fully closed.
2. Make sure fresh batteries are in the blaster.
3. Is the blaster turned on? On switch is located on the side of the blaster.
4. Check to make sure proper number of darts is loaded.

What if a dart gets jammed in my blaster?
On top of the blaster, there is an orange access slide that can be opened to remove any jammed darts. Remember to close the slide after you remove any jammed darts, so the blaster will fully function.

CherryRead More
12/30/2015 Nerf - N-STRIKE RECON Instructions and tips on how to use
N-STRIKE RECON Instructions and tips on how to use the Nerf Blaster

A few tips to consider for optimal blaster performance:
1. Make sure the clip has been correctly inserted.
2. Is the slide in the forward position? Slide must be in the forward position in order to fire.

What if a dart gets jammed in my blaster?
On top of the blaster, there is a black access slide that can be opened to remove any jammed darts. To open the access slide, make sure the blaster is cocked back.

CSN TeamRead More
12/30/2015 Nerf N-STRIKE RAYVEN CS-18 instructions, tips
Nerf N-STRIKE RAYVEN CS-18 instructions, tips and how to use

A few tips to consider for optimal blaster performance:
1. Make sure you are holding both triggers down.
2. The jam release door should be 'snapped' in place.
3. Make sure the clip does not contain more than 18 darts.

What if a dart gets jammed in my blaster?
On top of the blaster, there is a black access slide that can be opened to remove any jammed darts. Remember to close the slide after you remove any jammed darts, so the blaster will fully function.


CSN TeamRead More
12/30/2015 Nerf - Tips, Instructions and how to use N-STRIKE
Tips, Instructions and how to use N-STRIKE LONGSTRIKE by Nerf

A few tips to consider for optimal blaster performance:
1. Check the clip first to see if it is empty.
2. To insert or remove a clip, the blaster must be cocked all the way back.
3. To fire, make sure the blaster is cocked back all the way, before sliding forward. The black window on the top will change to red when this is done properly.

CSN TeamRead More
    Next Comments
Add a comment:

Please click on the number of stars to award for the company's customer service. Please do not enter personal information into the comments.

(Comments will be added pending approval by the webmaster.)

Company Rating:
Your Comment:
Your First Name or Nickname:
Your E-Mail Address (not published):